Snappi Seat Standalone Workshop Manual
Document No: 053-08 v2
Page 31 of 49
March 2019
Snappi Seat Standalone Workshop Manual.doc
Remove the cover from the side wing plate
and line the plate up with the mark centred
on the upper rear mounting hole- check to
ensure that there is a reasonable amount of
plastic over the rear holes, whilst still leaving
a 5mm gap to the back of the mounting
brackets (which is needed to provide
clearance for the cover) as shown in Fig
8.14, right.
Fig 8.14
Fig 8.15
Drill off the marked hole with a 5mm drill bit
as shown (see Fig 8.15, left).
