Snappi Seat Standalone Workshop Manual
Document No: 053-08 v2
Page 14 of 49
March 2019
Snappi Seat Standalone Workshop Manual.doc
Fig 7.2.3
Take note of the position of the 2 chamfers of the mounting blocks as these MUST be put
back in the correct orientation or the interface mechanism will not function properly.
Also take careful note of the orientation of the springs- the springs are handed and must be
re-fitted correctly or there will not be enough tension on the mechanism to close the clips.
To reassemble the interface, follow the reverse of these instructions and test as detailed in
section 4.4 of this manual.
7.3: Knee Angle Adjustor
Replace the seat knee angle adjustor if damaged or worn.
The replacement knee angle adjustor comes
supplied with: 1 x M5 x 30mm socket button
bolt, 1 x M5 x 35mm socket button bolt, 2 x
M5 Nylock Dome nuts, 4 x M5 Form A
Washers
Fig 7.3.1
Fig 7.3.2
Set the footrest to a horizontal position (i.e.
in line with the seat base) and place the
whole seat onto a flat surface.
Undo the nut and bolt securing the footrest
rod, taking note of the position of the bolt
head and washers, using a 3mm hexagon
key and an 8mm spanner.
