Snappi Seat Standalone Workshop Manual
Document No: 053-08 v2
Page 17 of 49
March 2019
Snappi Seat Standalone Workshop Manual.doc
Fig 7.4.1.3
Make sure the footrest locking screws are
loose, and then slide the footrest assembly
off the stems (see Fig 7.4.1.3).
Using a 3mm hexagon key and an 8mm
socket or spanner, remove the M5 bolt
securing the stem to the knee angle adjustor
(as shown in Fig 7.4.1.4). Take note of the
position of the washers. Then remove the
stems.
Fig 7.4.1.4
To fit the new stems: Follow the reverse of this procedure and fit with a new Nylock dome
nut (never re-use Nylock nuts).
7.4.2: Footrest Tray:
Remove the footrest slide assembly from the pushchair, to do this:
•
Remove the 2 x self-tapping screws from the end of the footrest stems.
•
Loosen the footrest slide locks
•
Slide the footrest assembly off the end of the stems.
For more details on this procedure please refer to section 7.4.1 above.
