Snappi Seat Standalone Workshop Manual
Document No: 053-08 v2
Page 11 of 49
March 2019
Snappi Seat Standalone Workshop Manual.doc
Fig 7.1.4
•
Tighten the m8 lock nut until there is
no movement between the pin and
release lever, then unscrew the gas
spring by ¼ of a turn. This ensures
that there is the correct amount of
play between the pin and release
lever. Do not over tighten
•
Finally secure the release head by placing a bar though the mounting hole and
tighten with the 13mm spanner.
IMPORTANT:
❖
Ensure that there is a small amount of play between the release lever and pin on the end of the
gas spring. If this is too tight, the gas spring may not lock correctly, or could have the
tendency to ‘creep’ when in a locked position.
7.1.1: Lock the Back Recline
The following instructions detail how to remove the back recline adjustment lever in order to
lock the back recline in a single position.
Fig 7.1.1.1
•
First, position the back rest to the
desired fixed position* (please refer to
the section 5.3.1 of the user manual
for how to adjust the angle of the
backrest).
•
Next, use a 13mm spanner to loosen
the black nut on the gas strut (3 turns
should be sufficient) as shown (see
Fig 7.1.1.1, left).
M8 lock nut
