59
6 Controlling the device remotely by DTMF commands and text message
6.1 Remote control and status query by DTMF commands via phone call
The device can be controlled and status query can be performed after calling the number of the
SIM card installed into the device. In order to gain access to controls, the device password will
be requested or not, according to
the setting configured in the “
Incoming call management
”
section for the given user phone number. When calling from a phone number which is not
configured in the device, the password will always be requested. The superadmin and admin
passwords are both accepted. Thereafter, the following commands can be used by pressing the
phone’s keys:
List of DTMF commands
Command
Specification
Module response
9password#
Entering the device password
Password accepted: 3 beeps
Wrong password: 4 low-tone beeps
0#
Disarm
3 beeps
1#
Arm
6 beeps
2#
Armed/disarmed status query
Disarmed: 3 beeps
Armed: 6 beeps
4#
GSM signal level query
The signal level will be indicated by
a number of beeps from 1 to 5
3RS#
Control the output(s)
R
: output (relay) number:
1
for the IN6.R1
model,
1
to
2
for the IN4.R2 model
S
: output state:
0
= open,
1
= closed
Becomes open: 3 beeps
Becomes closed: 6 beeps
3R9#
Output state query
R
: output number:
1
for the IN6.R1
model,
1
to
2
for the IN4.R2 model
Open: 3 beeps
Closed: 6 beeps
80MM#
Listen to voice messages
MM
: voice message number:
01
to
15
Playing voice message
89MM#
Record voice messages
MM
: voice message number:
01
to
15
Long beep, then recording for 10
seconds, then long beep again
85MM#
Delete voice messages
MM
: voice message number:
01
to
15
Successful operation: 3 beeps
Example:
1.
Incoming call management
setting: case of
option “
Accept call and request password
”
and
superadmin
or
admin
password: 1234
:
a.
Activating output OUT1
:
Enter the device password:
91234#
(accepted: 3 beeps)
Activate output OUT1:
311#
(output OUT1 activated/closed: 6 beeps)
b.
State query on output OUT1
:
Enter the device password:
91234#
(accepted: 3 beeps)
State query on output OUT1:
319#
(if output OUT1 is activated/closed: 6 beeps)
c.
Voice message recording to memory slot No. 03
:
Enter the device password:
91234#
(accepted: 3 beeps)
Record message:
8903#
(long beep) recording for 10 seconds (long beep)
2.
Incoming call management
setting: case of
option “
Accept call and don’t request
password
“:
Deactivating output OUT1
:
(3 beeps: password accepted)
310#
(output OUT1
deactivated/open: 3 beeps)
