DE910-DUAL AT commands reference guide
80392ST10102A Rev.2 – 2012-07-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 57 of 261
S0 - Number Of Rings To Auto Answer
ATS0=[<n>]
Set command sets the number of rings required before device automatically
answers an incoming call.
Parameter:
<n>
- number of rings
0 - auto answer disabled (factory default)
1..255 - number of rings required before automatic answer.
ATS0?
Read command returns the current value of
S0 parameter
.
Reference
V25ter
S1 - Ring Counter
ATS1
S1
is incremented each time the device detects the ring signal of an incoming call.
S1
is cleared as soon as no ring occurs.
Note: the form
ATS1
has no effect.
ATS1?
Read command returns the value of this parameter.
S2 - Escape Character
ATS2=[<char>]
Set command sets the ASCII character to be used as escape character.
Parameter:
<char>
- escape character decimal ASCII
0..255 - factory default value is 43 (+).
Note: the escape sequence consists of three escape characters preceded and
followed by
n
ms of idle (see
S12
to set
n
).
ATS2?
Read command returns the current value of
S2
parameter.
Note: the format of the numbers in output is always 3 digits, left-filled with 0s
