DE910-DUAL AT commands reference guide
80392ST10102A Rev.2 – 2012-07-03
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 49 of 261
+ILRR - DTE-Modem Local Rate Reporting
AT+ILRR=<n>
Set command controls whether or not the
+ILRR: <rate>
information text is
transmitted from the
modem
(module) to the
DTE
.
Parameter:
<n>
0 - local port speed rate reporting disabled (factory default)
1 - local port speed rate reporting enabled
Note: this information if enabled is sent upon connection.
AT+ILRR?
Read command returns active setting of
<n>
.
AT+ILRR=?
Test command returns all supported values of the parameter
<n>
Reference
V25ter
+ICF - DTE-Modem Character Framing
AT+ICF=<format>
[,<parity>]
Set command defines the asynchronous character framing to be used when
autobauding is disabled.
The DE910-DUAL family supports only the 8 Data, 1 Stop setting.
Parameters:
<format>
- determines the number of bits in the data bits, the presence of a parity
bit, and the number of stop bits in the start-stop frame.
3 - 8 Data, 1 Stop (default)
<parity>
- determines how the parity bit is generated and checked, if present; this
sub parameter has no meaning.
0 - Odd (not supported)
1 - Even (not supported)
AT+ICF?
Read command returns current settings for sub parameters
<format>
and
<parity>
.
AT+ICF=?
Test command returns the ranges of values for the parameters
<format>
and
<parity>
Reference
V25ter
Example
AT+ICF = 3 - 8N1 (default)
AT+ICF=?
+ICF: (3),(0,1)
D – Dial
