56051701
–
Rev A
2
© 2019 Telguard
Features
This section summarizes the key features of the Telguard TG-PEM.
Operating Modes
The TG-PEM can be used as a power supply only or as a power supply and zone expander.
Power supply only mode
The TG-PEM can be configured to operate only as a power supply from
This mode disables all zone
inputs and suppresses events and off-line status updates. The LED D2 will be solid amber when operating normally.
Power supply and zone expander mode
To work as a zone expander, the TG-7FS must have the minimum firmware version to operate with the TG-PEM. The LED
D2 will be solid green when the TG=PEM is properly configured and operating normally.
Power from Panel
TG-PEM can provide the Telguard system the correct power levels solely from the Fire or Burglary Control Unit (alarm
panel) auxiliary output power (for example, 24V
from an alarm panel’s auxiliary output).
Powering from the panel
eliminates the need for a dedicated AC outlet and backup communicator battery at the protected premises. Wire the
panel auxiliary power to the TG-PEM for the system to operate normally.
UL Note:
For all UL Listed installations, the input must to be power-limited by a panel that is UL Listed for compatible
listing and provides a regulated output of either 12VDC or 24VDC.
Refer to Appendix 4 for load calculations.
Note: When using panel power, the Telguard communicator should be powered exclusively from DC voltage supplied by
the TG-PEM. AC power source and battery are NOT used. Because there is no AC connection to the TG-7 or TG-7FS, the
AC Indicator (LED 8) will be OFF when operating in DC mode, and an AC Failure Condition (ACFC) will indicate insufficient
DC power available. As there is no battery for the Telguard system, the Low Battery Condition (LBC) will not be
applicable.
Dry Inputs
The TG-PEM provides eight dry inputs numbered 1 through 8 that may be configured to report trip events and/or restoral
reports. Each input can be configured for normally open, normally closed or supervised operation. The configuration
selections are made on
. A swinger feature is available.
