56051701
–
Rev A
7
© 2019 Telguard
Step 4: Mount the TG-PEM
Before beginning the installation of the TG-PEM inside the TG-7 series enclosure, use one of the screws
provided to pre-thread the screw holes in the metal mounting bracket. While not required, this will make
attaching the TG-PEM circuit board to the metal bracket much easier. The diagram below shows where to
pre-thread.
To mount the TG-PEM in the communicator enclosure:
•
Remove top left mounting screw that holds the TG-7 series board (indicated by arrow).
•
Orient bracket as shown in diagram.
•
Insert bracket at an angle so that top mounting point slides under board as depicted, and angled tab
threads through the enclosure bump out.
•
Replace screw to securely mount bracket and board.
•
Use the three provided mounting screws to secure the TG-PEM board onto the bracket in the holes that
you pre-threaded.
If a second TG-PEM (supporting 9-16 additional zones) is to be installed, do so after completing Step 5.
```
TG-7FS
LTE
Pre-thread using screws
LED1
LED2
LED3
LED4
LED5
LED6
LED7
LED8
DC STC2
STC1
TRIP BATT AC
