EN
37
36
the antenna that has been previously
stored
-SCR (only satellite band): Selects the SCR
parameters (multiswitch, standard and
slots) When a slot is enabled (for example
slot 3, freq. 1210MHz), the meter will tune
into the slot frequency (1210MHz) and
will set the slot with the meter parameters:
frequency, band (powering), and DiSEqC.
In addition, a SCR icon will be shown in the
bar at the top (SCR3) to indicate that the
slot is enabled. While the slot is enabled,
all the setting changes of the meter, will be
applied to the currently slot (SCR3).
6.4.7.- Echoes (RF Input)
This feature you allows to visualize the echoes
of the received signal, helping the installer to
minimize them as much as possible for optimal
signal reception.
6.4.7.1.- Main window
List of measurements of the
channel
Tap on i to see the parameters of
the signal
The blue mark indicates
the delay and the level of
the signal
Drag to move
Orange mark indicates
the minimun level of the
echoes
Drag to move
List of echoes
with the delay
and level of each
one
6.4.7.2.- Options context menu:
• Min. Level: allows to indicate the level from which
the meter must take account of the echoes. You can
also change this level by dragging the horizontal
orange level.
• Zoom: OFF, 2x, 4x, 8x, 16x. You can also Spread/
pinch on the screen.
• Units: us, Km.
• Quality profile: allows to select the quality profile
• Powering:
-
VDC: Selects the preamplifier powering.
-
DiSEqC (only satellite band): selects the
DiSEqC parameter (Sat A, Sat B, Sat C, Sat
D).
-
Positioner (only satellite band): makes it
possible to control the DiSEqC motors
used to move mobile parabolic antennas.
This function is available in satellite mode
and when the equipment is powering the
LNB.
Halt: This command stops the motor
movement.
East: Allows to move the motor in the
EAST direction. Each click corresponds to
one step in the movement of the motor
(pitch motors). By holding the key down,
successive movement sequences will be
executed until the key is released.
West: Motor movement in the WEST
direction. Each click corresponds to
one step in the movement of the motor
(pitch motors). By holding the key down,
successive movement sequences will be
executed until the key is released.
Store: 8 storage positions are available
