INSTALLATION INSTRUCTION
13
•
Connect the connector of the earthing conductor to the possible aluminium laminate or corrugated
steel tape armouring of the cable.
5.1.2.2 Slotted core cable
•
Remove the cable sheath and other protective layers up to the sheath removal point marked before.
•
Connect the connector of the earthing conductor to the possible aluminium laminate or corrugated
steel tape armouring of the cable.
•
Separate the fi bres or fi bre bundles from the slots. Take care that the fi bres don’t get mixed with each
other.
•
If the cable is supplied with a metallic central element, cut the slotted core with the central element
to the length of 20 cm. Strip the central element to the length of 15 cm.
•
If the cable is supplied with a non-metallic central element, cut the slotted core with the central ele-
ment to the length of 50 mm.
•
Clean the fi bres from the fi lling compound.
•
Bring the bundled fi bres into the tubes of the installation kit (accessory). Th
e minimum length of the
installation kit is 110 cm.
•
Push the installation kit around the slotted core in such a way that the fi bres in the slots are guided
directly into the protective tubes of the installation kit.
•
Fasten the installation kit to the slotted core with the clamp included in the installation kit. If the
fastening is not tight, use the small adjusting parts of kit under the clamp.
•
Mark the ends of the protection tubes by numbers 1, 2, …
