LCD 63SE (VG) Keypad
User Manual
17
Enabling / Disabling the Engineer Code Access
To enable / disable the Engineer code right to access the Engineer programming menu, the Man-
ager is required to enter a valid code first:
Pressing any numeric button alternatively changes the state of the parameter from enabled to dis-
abled and vice versa. The selected state is confirmed by pressing the
button .
By default the Engineer is allowed to enter the Engineer Menu .
Sending of “Comm. Manual test” Message
At this address the Manager can send a “
Communication Manual Test
” message to a central moni-
toring station or test message with the voice dialer VD60 (just in case there is integrated voice dialer
VD60 to the CA62 control panel) . The application of this function is to test the communication part in
the system from the manager, without need of sending the Engineer to the site .
To send a “Comm. Test” message, the manager is required to enter his code:
The communicator will start transmitting test messages through the digital communicator to the
central station first (if there are entered telephone numbers) and then through VD60 (if it is available
in the system and there are entered telephone numbers) .
UDL Access Block
At this address the Manager enters a permissible number of valid access codes for UDL (ARM /
DISARM / BYPASS / PC ID) for a 24 hour period . Enter a number from 00 up to 99 (the default set-
tings is
10 attempts
) .
With reaching the permissible number of valid access codes, the system will be blocked - there
would be no UDL communication . The UDL communication will be restored at 00:00h system time .
To enter a permissible number of codes, the manager is required to enter his personal code first:
code
default setting
disables the
Engineer access
confirm
code
2 beeps
exit from
the menu
code
2 beeps
digit 00-99
