10
PRISM MPI2-RACK-MD Installation and Safety Instructions
2.
Install the extended touch display in the right slot of the rack cabinet as viewed from the front. (See Figure 4.)
a.
Slide the extended display into the right slot in the rack cabinet as viewed from the front.
b.
Use a screwdriver with a TORX T-15 tip to secure the extended display in the rack cabinet with four 10-32 X
0.625 screws (item 3 in Table 4). The screws attach to all four rear corners of the instrument.
c.
Connect the display and USB cable (included) from the rear panel of the PRISM waveform monitor to the rear panel
of the extended touch display. The display cable must be connected from DisplayPort2 (bottom port) on the PRISM
waveform monitor to the DisplayPort on the extended touch display. The USB cable can be connected to any USB
port on the PRISM waveform monitor. (See Figure 6.)
d.
Connect the power cable to the extended touch display. (See
Figure 5: Connecting the cabinet USB and audio cables (use any USB port)
Figure 6: Connect the PRISM waveform monitor to the extended touch display
Summary of Contents for PRISM MPI2-RACK-MD
Page 6: ......
