PRISM MPI2-RACK-MD Installation and Safety Instructions
13
Operation
Extending the PRISM waveform monitor display
When the extended touch display is connected to a MPI2 instrument, you have the option to extend the MPI2 display.
Extending the display requires software option MP2-EXTNDSP, otherwise the extended touch display will mirror the MPI2
display.
1.
Connect the PRISM MPI2 waveform monitor to the extended touch display. (See Figure 6.)
2.
When software option MP2-EXTNDSP is present, go to the
Settings > Display
menu.
3.
In the
EXTENDED DISPLAY
setting, enable
Extended Display Mode
. If the Extended Display Mode setting is turned
off, then the second display will mirror the Primary display.
NOTE.
When Extended Display Mode is turned on, the HDMI video port on the MPI2 will not be available.
4.
When you first configure the extended display, you must run a short process to identify the two touchscreens to use. To
identify the touchscreens, press the
Start
button in the
Identify Touchscreen
setting.
5.
Follow the on-screen instructions. When instructed to touch the
Primary
and
Extended
displays, make sure to use a
touch gesture on the touchscreens and not with a mouse. The touchscreens will not be properly identified if you use a
mouse or if you configure remotely, such as with VNC.
NOTE.
The process to identify the touchscreens can be performed again at any time. When the process completes
successfully, it is not necessary to perform it again unless you change the touchscreen configuration. For example, if you
change the USB port connections on the back of the MPI2 instrument.
Figure 7: Extended display mode configuration
Summary of Contents for PRISM MPI2-RACK-MD
Page 6: ......
