R305 AT Commands
©2011 Telegesis (UK) Ltd
- 28 -
AT Command Manual (Rev 3.05)
+MATCHREQ
– Find Nodes which Match a Specific Descriptor (ZDO)
Execute Command
AT+MATCHREQ: <ProfileID>,
<NumInClusters> [,<InClusterList>],
<NumOutClusters> [,OutClusterList]
Where <ProfileID> Required profile ID of the
device being searched for followed by a
specification of required input and output
clusters.
If a remote node has a matching ProfileID
and matches at least one of the specified
clusters it will respond to this broadcast
listing the matching endpoint(s).
<NumInClusters> and <NumOutClusters>
must be 2 hexadecimal digits
Example
at+matchreq:C091,01,0002,02,0004,000B
Use on
All Devices
Response
SEQ:XX
OK
or
ERROR:<errorcode>
<errorcode> represents the error code explained in
section 3.
Prompt
MatchDesc:<NodeID>,<errorcode>,
XX,…
In case of an error an errorcode other than 00 will
be displayed and the prompt will end after the
errorcode.
Where <NodeID> is the Remote node‟s NodeID.
In addition all endpoints of this node matching the
search criterion are listed as 8 bit hexadecimal
numbers separated by commas.
SW release
R302
+ANNCE
– Announce Local Device In The Network (ZDO)
Execute Command
AT+ANNCE
Send a ZigBee device announce Broadcast
announcing the local node on the network.
Use on
All Devices
Response
OK
or
ERROR<errorcode>
<errorcode> represents the error code explained in
section 3.
Remote Action
Prompt
FFD:<EUI64>,<NodeID> [,syy,zz]
MED:<EUI64>,<NodeID> [,syy,zz]
SED:<EUI64>,<NodeID> [,syy,zz]
ZED:<EUI64>,<NodeID> [,syy,zz]
The prompt above will be displayed on all nodes
which can hear the announcement. In case bit C
of register S10 is set the RSSI level (syy dBm) and
LQI (zz in hexadecimal) of the last hop are
displayed. For a description of the LQI reading
please see section 7.
<EUI64> is the identifier and <NodeID> the
NodeID of the sending device
SW release
R302