R305 AT Commands
©2011 Telegesis (UK) Ltd
- 27 -
AT Command Manual (Rev 3.05)
+SIMPLEDESC
– Request Endpoint’s Simple Descriptor (ZDO)
Execute Command
AT+SIMPLEDESC:<Address>,<NodeID>,
<XX>
Where <Address> is the EUI64, NodeID or
Address table entry of the node which is to be
interrogated about the node with the NodeID
specified in <NodeID> and XX is the number
of the endpoint, which simple descriptor is to
be read.
Sends a unicast to obtain the specified
device‟s active endpoint list.
Use on
All Devices
Response
SEQ:XX
OK
or
ERROR:<errorcode>
<errorcode> represents the error code explained in
section 3.
Prompt
SimpleDesc:<NodeID>,<errorcode>
EP:XX
ProfileID:XXXX
DeviceID:XXXXvXX
InCluster:<Cluster List>
OutCluster:<Cluster List>
In case of an error an errorcode other than 00 will
be displayed and the prompt will end after the
errorcode
<NodeID> is the Remote node‟s NodeID. In
addition all active endpoints are listed as 8 bit
hexadecimal numbers separated by commas.
As with all unicasts after successful transmission
the sequence number of the unicast is stated using
the “SEQ:XX” prompt. When acknowledged (or
not) the accompanying “ACK:XX” (or “NACK:XX”)
prompt is displayed.
SW release
R302