R305 AT Commands
©2011 Telegesis (UK) Ltd
- 22 -
AT Command Manual (Rev 3.05)
+NTABLE
– Display Neighbour Table (ZDO)
Read Command
AT+NTABLE:XX,<address>
Where XX is the start index of the
remote LQI table and <address> can be
the remote node‟s EUI64, NodeID or
address table entry.
Note: Also the local node can be the
target of this command (e.g. use
address table entry FF as the address)
Use on
FFD, COO as the target device
Response
SEQ:XX
OK or ERROR<errorcode>
This command requests the target node to respond by
listing its neighbour table starting from the requested
index. Can be used to find the identity of all ZigBee
devices in the network including non-Telegesis devices.
Prompt (example)
NTable:<NodeID>,<errorcode>
Length:03
No.| Type | EUI | ID | LQI
00.| FFD | 000D6F000015896B | BC04 | FF
01.| FFD | 000D6F00000B3E77 | 739D | FF
02.| FFD | 000D6F00000AAD11 | 75E3 | FF
In this example the neighbour table of the remote node
with the short ID shown in <NodeID> contains three
entries (hexadecimal), which are displayed. In case the
table contains more than three entries it may be required
to repeat this command and increase the index count
until the full table is derived.
In case of an error an errorcode other than 00 will be
displayed and the prompt will end after the errorcode.
SW release
R302