Tektronix VM700T, User Manual

Page: 24 / 138

Installation
VM700T Option 01 (NTSC) & Option 11 (PAL) User Manual
1- 7
As a user, there are two things you may wish to do in the diagnostics mode.
These are setting the power on run mode (either to run the diagnostics at power
on or to skip them for a quick start) and calibrating the touch screen.
The touch screen is fully calibrated when shipped from the factory. Although it
will seldom be necessary, the touch screen can easily be recalibrated.
To calibrate the touch screen:
1. Switch off power to the measurement set at the front panel.
2. Press and hold the Menu button while turning on the power.
3.
After the measurement set beeps twice to acknowledge the startup mode,
release the
Menu button. The VM700T then initializes directly into the Low
Level Diagnostics Interface with the VM700T startup menu as shown in
Figure 1--3.
Low Level Diagnostic Interface
(knob moves cursor, “Select Line” inputs
selection)
Key Selection
________________________________________
H ... Diagnostics -HELP- Menu
R ... Instrument -RUN MODES- Menu
D ... Low Level -DIAGNOSTICS- Menu
________________________________________
= ... Reprint
________________________________________
Input your selection:
U ... -UTILITIES- Menu
T ... Calibrate -TOUCH PANEL INTERFACE-
--- VM700T STARTUP MENU ---
C ... Diagnostics -CONFIGURATION- Menu
@ ... Abort Menu
Figure 1- 3: VM700T Startup menu
4.
In the startup menu, use the large control knob to highlight the T in the
Calibrate Touch Panel Interface line.
5.
Press the
Select Line
button to make the selection to calibrate. The first
touch screen calibration instructions are then displayed as shown in
Figure 1--4.
Calibrating the Touch
Screen
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com