Tektronix TDS6404, Service Manual

Page: 21 / 252

TDS6000 Series Service Manual
1- 1
Specifications
This chapter contains the specifications for the TDS6000 Series. All specifica-
tions are guaranteed unless labeled “typical.” Typical specifications are provided
for your convenience but are not guaranteed. Specifications that are marked with
the
n
symbol are checked in chapter four, Performance Verification of the
service manual. Unless noted otherwise, all specifications apply to all TDS6000
Series oscilloscopes.
To meet specifications, the following conditions must be met:
H
The oscilloscope must have been calibrated in an ambient temperature
between 20
°
C and 30
°
C (68
°
F and 86
°
F).
H
The oscilloscope must be operating within the environmental limits listed in
Table 1--11.
H
The oscilloscope must be powered from a source that meets the specifica-
tions listed in Table 1--9 on page 1--16.
H
The oscilloscope must have been operating continuously for at least 20
minutes within the specified operating temperature range.
H
You must perform the Signal Path Compensation procedure after the
20-minute warm-up period, and the ambient temperature must not change
more than 5
°
C without first repeating the procedure. See Run the signal-
path compensation routine on page 4--6 for instructions to perform this
procedure.
Product and Feature Description
Your TDS6000 Series is shown in Table 1--1.
Table 1- 1: TDS6000 Series
Model
Number of
channels
Bandwidth
Maximum sample
rate (real time)
TDS6604 4 6 GHz 20 GS/s
TDS6404 4 4 GHz 20 GS/s