Tektronix PFG 5105, Instruction Manual

Page: 5 / 89

TABLE OF CONTENTS (Cont)
Section 3 PROGRAMMING (Cont) .................... 3-1
ID? (Identify) ........................................................ 3-15
INIT (Initialize) ...................................................... 3-15
MODE ................................................................... 3-16
NBURST (Number of Burst Cycles) ................. 3-16
OFFSE"r ................................................................ 3-17
OUTPUT ............................................................... 3-17
PERIOD ................................................................ 3-18
PRELEVEL ............................................................ 3-18
RATE ..................................................................... 3-19
RECALL ................................................................ 3-19
RNGLCK (Range Lock) ...................................... 3-20
ROS (Request for Service) ................................ 3-20
SEND .................................................................... 3-21
SET? ..................................................................... 3-21
STORE .................................................................. 3-22
SWEEP ................................................................. 3-22
TEST? ................................................................... 3-23
TRIG ...................................................................... 3-23
USEREQ ............................................................... 3-24
WIDTH .................................................................. 3-24 ,
MESSAGES AND COMMUNCIATION
PROTOCOL .................................................... 3-25
Command Separator .......................................... 3-25
Address and Message Terminator Selection ... 3-25
Formatting a Message ....................................... 3-25
Number Formats ................................................. 3-27
Rounding of Numeric Arguments ..................... 3-27
Message Protocol ............................................... 3-27
Multiple Messages ............................................... 3-28
Instrument Response to IEEE-488 Interface
Messages ............................................................. 3-28
ii
Remote-Local Operation ..................................... 3-29
Local State (LOCS) ............................................. 3-29
Local Without Lockout State (LWLS) ............... 3-29
Remote State (REMS) ........................................ 3-29
Remote With Lockout State (AWLS) ................ 3-29
STATUS AND ERROR REPORTING .................. 3-30
Sending Interface Control Messages ................ 3-35
POWER-ON SEQUENCES AND DEFAULT
SETTINGS ............................................................ 3-36
TALKER LISTENER PROGRAMS .................. 3-37
Talker Listener Program For Tektronix 4041
Controllers ............................................................ 3-37
Quick Basic Talker Listener Program For
Te k tronix PEP 301 Controllers ........................... 3-38
l WARNING
I
The following servicing instructions are for use
by qualified personnel only. To avoid personal
injury, do not perform any servicing other than
that contained in operating instructions unless
you are qualified to do so. Refer to Operators
Safety Summary prior to performing any service.
Section 4 MAINTENANCE .................................. 4-1
Introduction ............................................................ 4-1
Calibration/Adjustment .......................................... 4-1
Battery Replacement... .......................................... 4-1
Internal Fuse Replacement-PFG 5505 ............. 4-1
Fuse Replacement-PFG 5105 ............................ 4-2
Section 5 OPTIONS AND ACCESSORIES ........ 5-1
PFG 5105 Options ................................................ 5-1
PFG 5505 Options ................................................ 5-1
Optional Accessories ............................................ 5-1
PFG 5105/5505 Instruction Manual