Tektronix NetTek YBT250, User Manual

Page: 53 / 338

Operating Basics
YBT250 Field Transmitter & Interference Tester User Manual
2- 13
Using the Knob
To assign the knob to a control, tap the control to be changed.
Change the value by:
H
Tapping the left/right arrows on the bottom half of the control
knob to make small changes
H
Tapping to the left or right of the small circle (on the top half) to
make larger changes
H
Placing a finger inside the “circle” and dragging it left or right
until the control is set to the desired value
Using the Numeric Keypad
To change a value using the numeric keypad:
1.
Tap the control whose value is to be changed (to assign the value
to the numeric keypad).
2. Tap the numeric keypad button above the control knob.
3. Type the new value, including units when present.
4. Tap OK , when present, to accept the new value.
YBT250 Menus
The YBT250 menu bar has four menus. These menus are File, View,
Setup, and Tools. Some menu commands have keyboard shortcuts
for use when an optional keyboard is attached to the NetTek
Analyzer Platform, but not all menu commands have keyboard
shortcuts.
There are three menu commands in the File menu that change
depending on the displayed window. The commands are Save
Trace/Results, Save Trace/Results As, and Export Trace/Results.
Save Trace, Save Trace As and Export Trace commands appear
when the Spectrum and Interference windows are displayed (when a
signal spectrum is displayed). Save Results, Save Results As and
Export Results commands appear when the Measure window is
displayed (when measurements are displayed). See Tables 2--6
and 2--7.