Tektronix NetTek YBT250, User Manual

Page: 301 / 338

Appendix E: Functional Verification Procedure
YBT250 Field Transmitter & Interference Tester User Manual
E- 3
10. Tap Close to exit the diagnostic system.
Functional Tests
To perform the following tests, you must have an RF signal source.
Equipment Required
H
One 50
Ω
BNC cable, such as Tektronix part number
012-0057-01
H
One BNC-female to N-male connector adapter, such as Tektronix
part number 103-0045-00
H
An RF signal generator with a 10MHz reference output, capable
of generating a 100 MHz RF signal
Prerequisite
H
None
NOTE
. These procedures verify only that the YBT250 is operating
correctly. They do not verify that the YBT250 meets warranted
specifications.
Section 1: Check RF attenuation
To check the RF attenuation:
1. Power up the NetTek Analyzer Platform.
2. If necessary, launch the YBT250 application by double-tapping
the
YBT250 icon on the desktop or selecting Start>Pro-
grams>NetTek>YBT250 from the Taskbar.
3. Power on the RF signal generator.
4. Set the RF signal generator to a 100 MHz, --30 dBm output
level.
5.
Connect the BNC female-N male adapter to the YBT250 RF
INPUT connector.