Installation Instructions
18
TDS6UP, TDS7UP, and CSA7UP Option CPU Upgrade Kit
d.
Remove the floppy drive assembly from the NLX board assembly.
e.
Grasp the Riser board and pull it straight out to disconnect J510 edge
card connector from the NLX board. Remove the Riser Adapter board
from the NLX board assembly.
f.
Remove the CD drive from the NLX board assembly. Discard the NLX
board assembly.
5.
Remove the CD Drive bracket and Rom interface board:
See Figure 10 on
page 19.
a.
Remove the four #0 Phillips screws that secure the bracket to the CD
Drive. Remove the CD Drive from the bracket.
b.
Replace the CD Drive bracket with the one that came in your kit.
6.
Reinstallation:
Do in reverse steps 3 and 4 to reinstall the NLX board
assembly.
T--15 Torx
screw (2)
J510
NLX board
Riser adapter
board
NLX support
bracket
Floppy drive
cable
Hard drive
cable
connector
CD drive cable
connector
Figure 9: Riser adapter and NLX board removal