Tutorials
AWG610 Arbitrary Waveform Generator User Manual
2-53
Do the following steps to view the waveform you just loaded:
1. Push the View side menu button to display the waveform.
The waveform is displayed on the screen as shown in Figure 2–34.
2. When you are done viewing the waveform, push the OK side menu button to
exit the viewer.
Figure 2-34: Viewing a waveform loaded into memory
Do the following steps to output the waveform from the channel 1 output
connector:
1. Push the RUN button on the front-panel.
Pushing the RUN button causes the instrument to output the analog
waveform. Push the RUN button again to stop the waveform output.
. You must push the RUN button to output a waveform. The instrument does
not automatically output a signal after loading a data file unless the instrument
was in the Run state when you loaded the new data file.
2. Push the CH 1 OUT button near the CH1 output connector.
Pushing the CH 1 OUT button connects the channel 1 output to the CH 1
connector. Push the CH1 OUT button again to turn off the CH1 output.
View the Sample
Waveform
Output the Waveform
Summary of Contents for AWG610
