Tektronix AWG610, User Manual

Page: 377 / 466

Appendix B: Performance Verification
AWG610 Arbitrary Waveform Generator User Manual
B-17
Operating Mode Tests
The following procedures verify the operation of the Cont, Triggered and Gated
modes.
. When you output signal from the CH1 or CH1 OUTPUT, check that the
other OUTPUT ( CH1 or CH1 ) LED is off.
If the other OUTPUT LED is on, push the CH1 or CH1 OUT button to turn off
the output.
Equipment
required
A 50 W SMAĂcoaxial cable,ĂaĂSMA(Fe)ĆBNC(Ma)Ăadapter and an
oscilloscopeĂ(TDS700).
Prerequisites The AWG Arbitrary Waveform Generator must meet the prerequisites
listedon page B-8.
Do the following steps to install the test hookup and set the test equipment
controls:
1. Use a 50
W
coaxial cable to
c
onnect the AWG610 Arbitrary Waveform
Generator CH1 output connector to the oscilloscope CH1 input connector
(see Figure B–5).
OscilloscopeĂ(TDS700)
50 W SMAĂcoaxial cable
AWG610 Arbitrary Waveform Generator
SMA(Fe)ĆBNC(Ma)
adapter
ÁÁ
ÁÁ
Figure B-5: Cont mode initial test hookup
2. Set the oscilloscope controls as follows:
Vertical . . . . . . . . . . . . . . . . . . . . . . . . . CH1
CH1 coupling . . . . . . . . . . . . . . . . DC
CH1 scale . . . . . . . . . . . . . . . . . . 0.2 V/d iv
CH1 input impedance . . . . . . . . . . 50
W
Horizontal
Sweep . . . . . . . . . . . . . . . . . . . . . 200 ns/div
Check Cont Mode