Removal and Installation Procedures
Maintenance
6Ć10
List of Modules
Section 10 lists all modules.
Cable Removal
Usually cables are partially or completely removed as in the course of remov-
ing a module they plug into. However, all field replaceable cables are modules
and can be replaced by doing the
Access Procedure. Figure 6-4 shows the
cables and their routing.
General Instructions
READ THESE GENERAL INSTRUCTIONS BEFORE REMOVING A
MODULE.
First read over the
Summary of Procedures that follows to under-
stand how the procedures are grouped. Then read
Equipment Re-
quired for a list of the tools needed to remove and install modules in
this oscilloscope.
Reference Figure 6-1. Procedures refer to “front,” “rear,” “top,” etc. of
the oscilloscope; note from the figure which sides are referenced.
If you are disassembling this oscilloscope for cleaning, go to the
procedure
Disassembly for Cleaning on page 6-62.
If you are removing a module for service, begin by doing the
procedure
Access Procedure (page 6-13). By following the instruc-
tions in that procedure, you remove the module to be serviced while
removing the minimum number of additional modules.
Summary of Procedures
The procedures are described in the order in which they appear in this sec-
tion. In addition, you can look up any procedure for removal and reinstallation
of any module in the
Table of Contents of this manual.
H
The
Access Procedure on page 6-13 first directs you to the procedure(s)
that remove any modules that must be removed to access the module to
be serviced. It then directs you to the procedure to remove that module.
H
Procedures for Module Removal and Installation on page 6-21 are the
procedures for removing modules.
These procedures assume you have
done the access procedure.
Summary of Contents for 410
