Tektronix 1710J Series, Instruction Manual

Page: 69 / 252

Specifications
1710J-Series Waveform Monitors
4–3
Table 4–2: DC Restorer
Name Description
DC Restorer Clamp Time Backporch (J500 on/off)
n
Frequency Response at 60 Hz Slow — 20% or less
Fast — 90% or greater
Attenuation of 60 Hz on input signal (J399 Fast/Slow)
n
Blanking Level Shift with 10% to 90% APL
Change APL changes from 50% to either 10% or 90% will cause blanking level shift of 1 IRE
unit [7.14 mV] or less
n
Blanking Level Shift Due to Presence or
Absence of Burst 1 IRE unit [7.14 mV] or less shift from no color burst to presence of color burst
Table 4–3: Calibrator
Name Description
n
Frequency 100 kHz,
±
100 Hz, Synchronizes in 2H and 1H sweeps
Crystal controlled; timing accuracy is 10
m
s,
±
0.01
m
s, Can be used as 10
m
s and
1
m
s timing calibrator
n
Amplitude 140 IRE [1 V] within 1%
Position Top of waveform must be between 80 IRE (0.86 V) and 120 IRE [1.14 V] on graticule
when backporch is positioned to 0 IRE [0.300 V] line, with DC RESTORER on
Table 4–4: Horizontal Deflection
Name Description
n
Sweep Sweep will occur in all Horizontal mode settings with or without synchronization
n
2 FLD Sweep Repetition Rate Equal to frame rate of applied video or external sync
n
2 FLD Sweep Magnification Approximately X25
1 LINE Sweep Repetition Rate Equal to line rate of applied video or external sync
2 LINE Sweep Repetition Rate Equal to half line rate of applied video or external sync
Sweep Length 2 LINE and 2 FLD sweep length is nominally 12.5 divisions
n
Timing Accuracy 1
m
s/division
±
2%
0.2
m
s/division
±
3%
All timing and linearity specifications exclude the first and last major divisions of the
unmagnified display
n
Linearity 1
m
s/division and
0.2
m
s/division
Within 2%
n
Differential Linearity 1
m
s/division and
0.2
m
s/division
Within 2%