Tektronix 1710J Series, Instruction Manual

Page: 72 / 252

Specifications
4–6
1710J-Series Waveform Monitors
Table 4–10: Environmental Characteristics
Name Description
Operating Temperature 0
_
to 50
_
C (+32
_
to 122
_
F)
Storage Temperature –40
_
to 75
_
C (-40
_
to 158
_
F).
Operating Altitude To 15,000 feet (4572 meters)
Storage Altitude To 50,000 feet (15,240 meters)
Vibration 5 minutes at 5 - 15 Hz with 0.060 in. displacement
5 minutes at 15 - 25 Hz with 0.040 in. displacement
5 minutes at 25 - 55 Hz with 0.020 in. displacement
Military Specification: Mil-T-28800D, Paragraph 1.2.2, Class 3
Mechanical Shock Non-operating: 50 g 1/2 sine, 11 ms duration three shocks per surface (18 total)
Transportation Qualified under NSTA Test Procedure 1A, Category II (24 inch drop)
Humidity Will operate at 95% relative humidity for up to five days
Do not operate with visible moisture on the circuit boards
Table 4–11: Certifications and Compliances
EC Declaration of Conformity
1
Meets intent of Directive 89/336/EEC for Electromagnetic Compatibility. Compliance was
demonstrated to the following specifications as listed in the Official Journal of the European
Communities:
EN 50081-1 Emissions:
EN 55022 Class B Radiated and Conducted Emissions
EN 50082-1 Immunity:
IEC 801-2 Electrostatic Discharge Immunity
IEC 801-3 RF Electromagnetic Field Immunity
IEC 801-4 Electrical Fast Transient/Burst Immunity
Low Voltage Directive 73/23/EEC:
EN 61010-1
Safety requirements for electrical equipment for measurement,
control, and laboratory use
EN 61010-2-031:1994 Particular requirements for hand-held probe assemblies for
electrical measurement and test
EMI
1
FCC 47 CFR Part 15, Sub-part B, Class A
Installation (Overvoltage) Category Terminals on this product may have different installation (overvoltage) category designations.
The installation categories are:
CAT III Distribution-level mains (usually permanently connected). Equipment at this level is
typically in a fixed industrial location.
CAT II Local-level mains (wall sockets). Equipment at this level includes appliances, portable
tools, and similar products. Equipment is usually cord-connected.
CAT I Secondary (signal level) or battery operated circuits of electronic equipment.