Programming The Unit Identification
The Unit Identification (UID) is identical to the instrument’s
number and is
stored in NV RAM. It is
to enter this number if the Al Main board is
replaced
if data in NV RAM becomes corrupted. If confirmation only of the UID
is needed, then
the following procedure except skip step 4.
To enter the UID, use this procedure:
1.
2 .
3 .
4 .
5 .
7 .
8 .
Connect a Terminal to the mainframe’s RS-232-C port. (Refer to the main-
frame
User’s Reference
Manual for instructions
on setting up
the RS-232-C
parameters.)
Inside
plug-in, move the jumper
(shown in Fig.
on the Al Main
board. The jumper should be vertical in its
position. Remove the
jumper and install it horizontally.
Install the plug-in into any compartment. Turn the power on. Wait until the
Diagnostics checks
completed.
At the Terminal, type the command:
UID [Left
Serial
.
Left Center Right refers to the name of the compartment.
At the Terminal, type the command:
UID? [Left Center Right]
Set the ON/STANDBY switch to STANDBY.
Remove the plug-in.
Reinstall the jumper
to its vertical position on the Al Main board.
3-20
Maintenance- 1
Service Reference
Summary of Contents for 11A32
