5.
9.
11.
12.
13.
14.
Use a
to start the screws fastening
sink
to the Al Main board.
Tighten the screws that you
in
3, 4, and 5.
the MOE holders on the bottom of the Al
board and
MOE
the holders as shown in Figure 3-5.
Slide the front panel and attenuator
into position, being careful
dislodge the MOE strips or holders.
Hold the attenuators against the MOE strips and
all of
which
attach the attenuators to the Al Main board.
Use a Ton: T-8 screwdriver to install the four
that fasten the front
panel
top and bottom frames.
Use a
T-8
to tighten the screws installed in step 9.
cable(s) from the A2 Front-Panel board to the
the Al Main board.
Install the
bar return spring. Orient
spring so that its loop fits
the frame hook correctly (flat against the frame section).
If the Al Main board has been replaced, the”
Unit Identification (UID)
“umber needs to be
Refer to instructions in
“Programming
The Unit
which follows.
Maintenance-
Service Reference
Summary of Contents for 11A32
