12
Connect the top part of the manual
pulse rate cable (26) and the central
part (25). Push any excess cable back
down into the main post (7), slide the
monitor (11) onto the plate on the main
post (7) and screw it into position.
Figure 6
A)
Slide the top right-hand handlebar
(12) onto the right-hand central
handlebar (8) using the flat washers
(22) and bolts (21) to secure it.
B)
Slide the top left-hand handlebar
(13) onto the left-hand central
handlebar (9) using the flat washers
(22) and bolts (21) to secure it.
C)
Remove screws (B) (23) located on
the main post (7) and fiit the bottle
holder using the same screws (23).
Figure 7
LEVELLING
Once the appliance has been placed
into its fi nal position, make sure that it
is level on the floor. This can be
achieved by screwing the adjustable
blocks (33) on the rear stabiliser bar
(3) either in or out, as shown in Fig. 7.
Figure 8
REPOSITIONING
There are two
wheels (32) located at the front to make
it easier to move the appliance about,
see Fig. 8.
Do not hesitate to get touch with the
Technical Assistance Service if you
have any queries by phoning customer
services (see last page in manual)
THE MANUFACTURER RESERVES
THE RIGHT TO MODIFY THE
SPECIFICATIONS
OF
ITS
PRODUCTS
WITHOUT
PRIOR
NOTICE.
