Tecnoalarm TP8-64, User Manual

Page: 67 / 76

TP8-64 - User Manual Control by keypoint
5-9
5.4 CONTROL BY TP SDN ELECTRONIC KEYPAD
The electronic keypad permits the control of the first 4 programs of the control panel with code, even if the codes can be
enabled for 8 programs. Codes enabled for the programs 4 to 8 are not recognized by these electronic keypad . It does
not accept the installer code and does not permit programming.
5.4.1 ARMING
The electronic keypad permits arming/disarming and by-pass of the first 4 programs with master code or standard user
code enabled for the program in question.
The programs group the zones (1 to 64) that are activated, i.e. are enabled for the detection of alarms, simultaneously
upon arming of the program. The programs can be armed one at a time (single arming) or simultaneously (multiple
arming).
The electronic keypad permits arming with exclusion of open zones.
Common zones (if multiple arming is enabled only)
If a zone is included in several programs and is defined as common zone, it is only enabled for the detection of alarms
when all the programs it is included in are armed.
Example: if a system is used by two appartments that share the same entrance zone, the owners of the appartments
can arm the proper part of the system independently through the program/s associated to it and with the proper user
codes. The common zone (entrance), however, is activated only if the programs of both appartments it is included in are
armed simultaneously.
CHECK SYSTEM STATUS
Prior to arming of the control panel always check system status with the help of the
LED on the keypad:
z
Yellow LED 7 OCG
blinking
= control panel armed and one of the programs associated in
alarm
on = alarm memory
z
Red LED 6 general alarm
blinking
= trouble or general alarm active (e.g. low battery, power failure,
tamper)
on = alarm memory
CHECK ZONE STATUS
Open zones/active zone alarms are not signalled unless you try to arm the control
panel. In the arming phase the yellow LED 7 OCG signals zone status:
z
LED blinking = open zones
z
LED off = zones ok