Tecnoalarm TP8-64, User Manual

Page: 51 / 76

TP8-64 - User Manual Control by console
4-9
4.1.7 ARMING DENIED
In presence of trouble/general alarm arming is not permitted with:
z
Code (master or standard user) unless it is enabled for the by-pass of general
alarms
z
Quick arming command
z
Key zone
On the attempt at doing so, on the display is viewed ! ARM. DENIED ! followed by
the kind of alarm.
Remove the reason of alarm or use a code enabled for the by-pass of general alarms.
4.2 DISARMING
The control panel can be disarmed through the programs (1 to 8) in one of the following
ways:
z
with master code or standard user code enabled for the program in question
z
with quick arming command
z
with contact connected to a key zone
z
automatically by timer
4.2.1 DISARMING WITH MASTER CODE
Enter the master code (default code 12345), e.g.:
+
12345
For the 10 seconds to come, it is possible select the programs to be armed/disarmed
(pressing the program number once the program is selected, pressing it again the
program is deselected).
On every keystroke the counter is reset.
Select the programs to be disarmed, e.g.:
+
12
For 10 seconds, on the display is viewed Disarm. followed by the number/name of the
programs selected. The yellow LED corresponding to the programs selected are
switched off.
It is possible to confirm the selection and abort the 10-seconds wait by pressing:
+
#
4.2.1.1 TOTAL DISARMING
After selecting the master code and during the 10 seconds destinated for the selection
of the programs it is possible to obtain total disarming, i.e. disarming of all the programs
by pressing:
+
*
NO to disarm all the programs
The yellow LED corresponding to the programs disarmed are switched off and the
control panel returns to stand-by.
4.2.2 DISARMING WITH STANDARD USER CODE
Whereas the master code is always enabled for all the programs, the standard user
codes merely control the programs the have been enabled for by the installer or the
holder of the master code.
Enter a user code appropriately programmed, e.g. standard user code number 1:
+
11111
For the 10 seconds to come, it is possible to select the programs to be armed/disarmed
(pressing the program number once the program is selected, pressing it again the
program is deselected).
On every keystroke the counter is reset.
Select the programs to be disarmed, e.g.:
+
12
Procede as for disarming with master code (see § 4.2.1).
4.2.2.1 TOTAL DISARMING
See § 4.2.1.1.
! ARM. DENIED !
Low battery
- ACCESS -
Master
Disarm.
Program x
WARNING
To abort disarming of the programs selected, press the EXIT key. The process is aborted and the
programs previously armed remain such.
- ACCESS -
User 001