Tecnoalarm TP8-64, User Manual

Page: 21 / 76

TP8-64 - User Manual Signaling
2-7
The general alarm LED signals general alarms as follows:
z
LED blinking = a general alarm is active
z
LED on = a general alarm has been stopped and stored in the event
buffer of the control panel (alarm memory).
z
LED off = no alarm has occurred
The general alarms are logged in the event buffer of the control panel.
2.2.3 KEYPAD STATUS LED - GREEN
The green keypad status LED signals the status of the electronic keypad:
z
LED on = a valid code has been entered (master or standard user
code)
z
LED off = the keypad is in stand-by
z
LED blink.quickly = someone is arming the system through another console/
electronic keypad
z
1 flash = keystroke
2.2.4 PROGRAM STATUS LED - RED
The red program status LEDs signal the status of the first 4 programs (1...4) as follows:
z
LED blink. quickly = the pre-arming phase is active.
The pre-arming phase permits arming/disarming of other
programs. Then, the volontary exclusion of zones from the
detection of alarms is possible.
z
LED blink. slowly = the program is partset.
The zones included in the by-pass program are temporarily
disabled from the detection of alarms.
z
LED on = the program is armed
z
LED off = the program is in stand-by
Arming and disarming as well as the activation and deactivation of by-pass are logged in
the event buffer of the control panel.