Tecnoalarm TP8-64, User Manual

Page: 11 / 76

TP8-64 - User Manual General Features
1-1
1. GENERAL FEATURES
The control panel TP8-64 is a new generation microprocessor-based control panel. It controls a minimum of 8 and a
maximum of 64 zones, which can be freely associated to the inputs of the CPU board, the plug-in expansion module,
the input modules connected via serial line and the plug-in radio expansion.
The control panel is programmed by the installer using a PC or an LCD console (LCD200 or LCD300/S).
The holder of the master code can execute simple settings through LCD console whereas all of the users can
arm/disarm or partset the system by code or electronic key.
1.1 CODES
The system distinguishes two user levels:
Master
The master code permits limited programming as well as arming/disarming and partset
of the system. This code is usually reserved to the owner of the system as it can
program or modify the standard user codes.
Enter the master code to enter the master menu.
The default code is 12345, and can be modified by the master.
Standard user
The standard user codes (max. 62) permit merely arming/disarming and partset of the
system.
Enter the user code to arm/disarm or partset the programs it has been enabled for.
The standard user codes are programmed and modified by the master, there are no
default settings.
1.1.1 MASTER MENU
The master code permits:
z
Date and time setting
z
Association of chime to the zones (acoustic open zone signaling with the
program in stand-by)
z
Creation and modification of the programs
z
Programming of 16 timers for automatic arming
z
Programming of 8 access periods (periods of time during which the codes and
keys are enabled)
z
Programming of the telephone parameters:
•
Enabling of the answering mode (answering to incoming calls)
• Defines the number of ringback
• Programming of the PABX number if the control panel is connected behind
a PABX internal switch board
• Programming of the telephone numbers (2 numbers per channel)
• Volontary execution of a call back
• Enabling of the answering mode on the GSM interface TECNOCELL
• Programming of the emergency number of the GSM interface (to be called if the
communication between the control panel and the communicator is interrupted)
z
Programming or modification of the values of the user codes (master and standard
user codes 1...62) and the functions they are enabled for
z
Programming of the electronic keys (1...32)
z
Programming of the wireless keys (1...32)
z
Enabling of the consoles connected (1...15)
z
Programming of the volume of sounding of the console for the vocal message
z
Volontary exclusion of modules (e.g. in case of bad functioning)
z
Enabling of remote access (permitting the installer to control or program the
system via telephone line using the remote control software)
z
Access to ambiente di test per il controllo della funzionalità della centrale.
z
Remote control (activation/deactivation of 1...8 devices)
z
Arming/disarming of the programs 1...8
z
Total disarming (disarming of all programs)
z
Partial disarming (disarming of some of the programs armed)
z
Quick arming/disarming (using the keys
#
and
*
)
z
Viewing of the contents of the event buffer
z
Erasement of the events stored
z
Communicator block (interruption of the active telephone calls)
LCD200
LCD300/S