Tecnoalarm TP8-64, User Manual

Page: 49 / 76

TP8-64 - User Manual Control by console
4-7
WARNING
The zones definded as NOT EXCLUDIBLE are not listed. If a zone is already excluded it does not
appear in the list either.
Once you have excluded all the zones you wanted to exclude, it is possible to confirm
the exclusion and procede with arming without awaiting expiry of the zone exclusion
time by pressing:
+
EXIT to confirm the exclusion and abort the zone exclusion time
If all the zones are excluded, the process is stopped automatically.
IMMEDIATE CONFIRMATION OF ARMING
The zone exclusion time stops approximately after 10 seconds from the exclusion of the
last zone.
It is possible to abort the wait and obtain immediate arming by pressing:
+
#
The zones remain excluded until disarming of the program. They are activated
automatically again the next time the program is armed.
4.1.1.3 TOTAL ARMING
After entering the master code and during the 10 seconds destinated for the selection of
the programs, it is possible to obtain total arming, i.e. arming of all the programs by
pressing:
+ #
YES to arm all the programs
The control panel initiates the zone exclusion time.
The corresponding yellow program LED start blinking.
4.1.2 ARMING WITH STANDARD USER CODE
Whereas the master code is always enabled for all the programs, the user codes control
merely those programs they have been enabled for by the installer or the holder of the
master code.
Enter the user code appropriately programmed, e.g. standard user code number 1:
+
11111
For the 10 seconds to come, it is possible to select the programs to be armed/disarmed
(pressing the program number once the program is selected, pressing it again the
program is deselected).
On every keystroke the counter is reset.
Select the programs to be armed, e.g.:
+
12
Procede as for arming with master code (see § 4.1.1).
4.1.2.1 TOTAL ARMING
See § 4.1.1.3
4.1.3 QUICK ARMING (IF ENABLED)
It is possible to speed up the arming process by pressing the key * (star) followed by
the program number, e.g.:
+
*1
+
*2
Repeat the command for all the programs to be armed.
WARNING
The programs that are already armed are not influenced.
To abort arming of the programs selected press the
EXIT key. The process is aborted and the control
panel returns to stand-by.
- ACCESS -
Master
- ACCESS -
User 001
WARNING
Quick arming is only permitted through the consoles that have been programmed appropriately by the
installer.
It is not permitted in case of trouble/general alarm or fault (low battery, power failure etc.). At the
attempt at doing so, on the display is viewed
! ARM. DENIED ! followed by the kind of alarm.