Technogym ISOCONTROL, Service Maintenance Manual

Page: 56 / 72

ISOCONTROL: Service & Maintenance Manual - rev. 1.2
Pagina 7.4
7.4. DISASSEMBLING THE ENCODER BOARD ON ELEMENT
MACHINES
Figura 7.4-1
1. Back off the screws a , using a 4-mm hex
wrench.
2. Remove the front casing.
3. Disassemble the rear casing, carrying out the
procedure here above, on the rear side of the
machine.
Figura 7.4-2
4. Disconnect the cable (ISO-03).
5. Remove the plate which hold the encoder
using an 8-mm hex wrench and a 17-mm
wrench for the nut
b .