Technogym ISOCONTROL, Service Maintenance Manual

Page: 23 / 72

ISOCONTROL: Service & Maintenance Manual - rev. 1.2
Pagina 5.7
MODEL B
T
he hole must be drilled at about 392 mm from
the upper part of the top (see dimensions in the
figure), on the flat inner portion of the elliptical
tubing, at the centre point.
The machine in figure is viewed from behind.
MODEL C
The hole must be drilled at about 202 mm from
the upper part of the top (see dimensions in the
figure), on the flat inner portion of the elliptical
tubing, at the centre point.
The machine in figure is viewed from behind.
MODEL D
The hole must be drilled about 212 mm from the
upper part of the top (see dimensions in the
figure), on the flat inner portion of the elliptical
tubing, at the centre point.
The machine in figure is viewed from behind.