Technogym ISOCONTROL, Service Maintenance Manual

Page: 24 / 72

ISOCONTROL: Service & Maintenance Manual - rev. 1.2
Pagina 5.8
MODEL E
The hole must be drilled about 262 mm from the
upper part of the top (see dimensions in the
figure), on the flat inner portion of the elliptical
tubing, at the centre point.
The machine in figure is viewed from behind.
MODEL F
The hole must be drilled on the center line of the
machine, on the flat inner portion of the elliptical
tubing, at the centre point
The machine in figure is viewed from behind.
MODEL G
The hole must be drilled about 127 mm from the
upper part of the top (see dimensions in the
figure), on the flat inner portion of the elliptical
tubing, at the centre point.
The machine in figure is viewed from behind.