11
Step 7:
•
Mount the syringe bracket (8)
by sliding it on the side of the
valve, then use the 3mm hex
wrench to install the provided
M4 screw (9) to secure the
bracket in place.
•
Insert the syringe into the
bracket. Connect the syringe to
the valve inlet fitting (10).
Step 8:
•
Connect the valve cables to the
controller. Sensor cable (6-to-5
pins) to the ‘SENSOR’ port
(11); Actuator cable (3-to-2
pins) to the ‘ACTUATOR’
port (12).
Caution
: After
connecting, tighten the locking
sleeve
to
secure
the
connection.
•
Connect the power cord to the
‘DC-IN’ port (13).
•
Wi-Fi antenna (Not available)
Step 9:
•
Connect the first ø4mm OD air
tubing from the air pressure
source to the ‘IN’ port (15).
Warning:
This
Air source
must be
regulated and filter
(dry)
separated from the air
pressure source for the material
syringe or reservoir.
•
Connect the second ø4mm OD
air tubing from the ‘OUT’ port
(16) to the air fitting on top of
the Jet Valve (17).
•
Turn up the air pressure for
cooling to the maximum of 10
psi.
