4-3
4. PROGRAM DOWNLOAD
EO18-33014
4.2 COMMUNICATION PARAMETERS SETTING
This section provides communication parameters setting for the PC to perform the firmware download to the
B-SP2D printer. As the communication parameters, device, parity, interface, baud rate, and forced download
mode can be set.
4.2.1 Communication Conditions
1. From the [tool(T)] drop down menu select [Condition(C)].
2. Select desired settings for device, parity, interface, and baud rate. Then click on the [OK].
NOTES: 1. After the PC starts up, COM1, None, RS-232C, and 9600bps are programmed as default
setting.
2. To perform Forced Download, make a check in the check box "Forced download mode".
3. From the firmware version V1.1, IrCOMM protocol has been supported. When downloading
the firmware by using the IrCOMM protocol, be sure to turn the printer to the system mode, as
this is the only mode that enables downloading with the IrCOMM protocol. In case of Win-
dows 95 and Windows 98, the data will be output to a virtual COM port. Set the virtual COM
port for the Device. In case of the forced download, be sure to use the TEC protocol regard-
less of the protocol set for the printer.
(Revision Date: Jan. 29, 2004)
4.2 COMMUNICATION PARAMETERS SETTING
NONE
