2-29
2. MAIN UNIT REPLACEMENT
EO18-33014
(Revision Date: Jan. 29, 2004)
2.7 SETTING AND ADJUSTMENT
NOTE:
If the adjustment values of the no paper level of the reflective and transmissive sensors are out of
the judgement criterion, an error message will appear. When clicking on the OK button of the error
message window, the A/D values will be displayed. In this case, however, an "Error" is shown in
place of the A/D values for the reflective and transmissive sensor of no paper level. Readjust these
sensors.
2.7.4 Registering Destination
While holding down the [FEED] switch on the printer, turn the printer ON. After the printer is initialized (LED
blinks in red), the LED will blink in green for several seconds, then printer prints the self-test result.
To register the destination, face the IrDA jig (Actisys IR) to the upper IrDA window of the printer in this state,
then press the [F10] key of the keyboard, or click on the [F10: Registration] button on the screen.
The destination will be registered. When the destination registration is normally completed, the message “The
destination has been registered.” will be displayed. The interface to be used for registering the destination,
should be “IrDA: TEC Protocol”.
4) Adjusting no paper level
Without placing the paper in the printer, press the [F6] key of the keyboard, or click on the [F6: No paper
level] button on the screen. The no paper levels for the reflective and the transmissive sensors will be
adjusted. When the adjustments are completed, all of the current sensor A/D values will be displayed.
