2-21
2. MAIN UNIT REPLACEMENT
EO18-33014
5
Checksum (FONT)
FONT
xx00
2.6 TEST PRINT
Checksum for the C/G area
6
Checksum (Writable character)
KANJI
xx00
NOTE: Chinese character will be printed when supported by the printer.
Checksum for the writable character area
7
Sensor status
SENS
R:4.3V
Black mark sensor status
T:1.2V
Feed gap sensor status
P:1.0V
Strip/Batch
H:+30
°
C
Thermistor status
A:+24
°
C
Print head termistor status
NOTE:
Make sure that each sensor's voltage satifsies the standard below. If the voltage doesn't
satisfy it, this sensor may be damaged. In this case, perform a sensor adjustment or replace
it with the new one. (For the sensor adjustment, refer to Section 2.7 SETTING AND
ADJUSTMENT.)
R: 3.5V or more, T: 1.5V or more, P: 3.5V or more
H: (t-5) ~ (t+20)
°
C
t = Environmental temperature
A: (t-5) ~ (t+5)
°
C
8
Threshold
PEEL
3.2V
Threshold voltage of strip sensor
9
Destination code
TYPE
QM
Destination code
10
Printer ID No.
ID
01234
Printer ID No.
11
Print head element check
HEAD OK
(2)
Check result of the print head broken element
(OK: Normal, NG: Broken element)
Print head output dividing method
(AUTO, 2, 3, AUTO 1)
12
Battery status
BATT
8.2V
(5)
Remaining battery voltage
5 levels of the remaining battery voltage
NOTE:
When the check result is NG, the print head element may be broken. In this case, replace
the print head with the new one.
NOTE:
Using a battery fully charged, make sure that the remaining voltage is 7.6V to 8.4V. If is is
less than 7.6V, a battery failure may occur. In this case, replace the battery with the new
one.
