Teac FD-55 Series, Maintenance Manual

Page: 58 / 216

Claxtip securelv
Stopper (push)
Cable
Contact area
Housing clamper
(Fig,403) Sectional view of white connectors
ii) Confirm that the stopper is lifted as in Fig.403 and it inhibits
accidental removal.
iii) No tarnish or contamination should be on the contact area of the
pin or the PCB side post pin. If there is, remove it.
Contact failure may happen ,if any of these three points is not
satisfied.
When you insert the pin, it should be- so inserted that the stopper
faces the opening side of the housing.
After the insertion, check the connection by pulling the cable lightly.
(4) Precautions for handling the black connectors (J4, J 5 , J 9 , J1Q, Jll)
(a) Disconnection of the connector
i) Pull out J4 connector (head load solenoid and track 00 connector)
slowly holding the cable with a pair of tweezers or a round nose
pliers carefully.
ii) For pulling out J5 (PCBA front OPT connectorl and J9 (head
connector), remove the screw fixing the cord guide (see Fig.501,
No.l) and pull the connector holding the cable and housing slowly.
Be sure not to apply tension to the fine cables of the J9 (head
connector).
4018