Teac FD-55 Series, Maintenance Manual

Page: 158 / 216

r.
(15) Check and adjust the CSS Ass'y according to item 4-4-5. (Only for the
double sided CSS models).
(16) Execute head cable treatment according to item 4-2-3.
(17) Make the head seek continuously between the track 00 and the innermost
track and confirm that the steel belt does not meander nor undulate.
When the SKA is used, key in " C6" for this check and key in "F" for
stop.
If there is some abnormal running of the steel belt, readjust the
belt with two screws in item (4) and one screw in item (8). After
the adjustment tighten the screws carefully with the specified torque.
(18) Check and adjust the head touch according to item 4-4-9.
(19) Check and adjust the asymmetry according to item 4-4-10. (Adjustment is
applied only for the models equipped with variable resistor, R5 on the
PCBA MFD control).
(20) Adjust the track alignment according to item 4-4-13.
(21) Adjust the track 00 sensor position according to item 4-4-14.
(22) Adjust the track 00 stopper position according to item 4-4-15.
(23) Check and adjust the index burst timing according to item 4-4-16.
(24) Check for the read level according to item 4-4-11.
(25) Check for the resolution according to item 4-4-12.
*
(26) It is recommended to connect the FDD to the system for overall test.
(Refer to item 4-2-5, (1)).
- 4120