Teac FD-55 Series, Maintenance Manual

Page: 161 / 216

r.
after cleaning the surface carefully with -alcohol -and gaufce.
2. Never remove the plate of the stepping motor A s s ' y since they
are combined each other.
(7) Install the stepping motor in item (6) according to the reverse order
of items (1) through (4). a- _ . ^ ^ "r rrr
(8) Loosen the screw which fixes the belt to the capstan.— P
(9) After moving the head carriage several times manually, tighten the
fixing screw of the steel belt in item (8) carefully with the specified
torque. At this time, be carefull so that the belt is tensioned
straightly. Pay attention not to damage the surface of the belt or
the capstan. — ~
(10) Loosen the fixing screw (Fig.506, S8) of the track 00 stopper (Fig.506,
No.4) to shift the stopper toward the rear side of the FDD.
(11) Make the head seek continuously between the track DO and the innermost
track and confirm that the steel belt does not meander nor undulate.
When the SKA is used, key in ^06* for this check and key in ^F" for stop.
If there is some abnormal running of the steel belt, xeadjust the
belt with two screws in item (4) and one screw in item (8). After
the adjustment tighten the screws carefully with the specified torque.
(12) If the steel belt is replaced, execute the continuous seek in item (11)
for five minutes, approx.
(13) Adjust the track alignment according to Item 4-4-13.
*
(14) Adjust the track 00 sensor position according to item 4-4-14.
(15) Adjust the track 00 stopper position according to item 4-4-15.
- 4123