TC Electronic REVERB 4000, User Manual

Page: 50 / 61

48
VSS-4 TS (TRUE STEREO)
Main page
Reverb 1 - Reverb 2
Link
The Link mode is used to link parameters
between the Reverbs 1 and 2. E.g. if “Link 1+2”
is selected the Master Decay of both Reverb 1
and Reverb 2 is controlled by a single handle.
Pre Delay
Range: 0 - 300ms
Adjusts the Pre Delay
Decay
Adjusts the Master Decay time.
Hi Decay
Decay multiplier for Reverb A hi-end
frequencies. For a x1.0 setting, high frequency
decay will equal the Decay setting.
Wet Level
Range: Off to 0dB
Input level adjust.
If the input signal is close to full scale and/or
long decay times are used, it may be necessary
to attenuate the input to avoid overload.
Dry Level
Range: Off to 0dB
Dry Level control.
In send/return configurations, the parameter
should be set to Off.
Rev1/Rev2 page
Reverb
Decay
Master Decay parameter. This parameter is
also found on the Main page.
Rev. Diffuse
Range: -50 to +50
This parameter offsets the diffusion away from
what is considered optimum for a given Decay
time.
Build
Range: Fast, Slow
Selects the speed of the build-up (i.e. attack) of
the reverb.
Reverb Type
By selecting different types or different version
(A, B, C, D), de-correlated responses are
ensured.
Reverb Lo/Hi Cut
Lo Cut
Range: 20Hz to 200Hz
Determines the Lo Cut frequency. Attenuation
amount is controlled via the Lo Damp
parameter.
Lo Damp
Range: 0 to -18dB
Attenuation amount of frequencies below the Lo
Cut setting.