TC Electronic REVERB 4000, User Manual

Page: 40 / 61

38
VSS-4
Positions
Range:
R 30º, R 15º, R 7º, C 0º, L 7º, L 15º, L 30º
Sets the location of the two Input sources.
Depending on the Location Type the number of
positions can vary. Typically a small room has
less positions than a large location. Source 1 is
Left Input and Source 2 is Right Input
Note - in 96kHz position B is eliminated.
Color page
Reverb
Lo Cut
Range: 20Hz to 200Hz
Determines the Lo Cut frequency.
Attenuation amount is controlled via the Lo
Damp parameter.
Lo Damp
Range: 0 to -18dB
Attenuation of the frequencies below the
selected frequency via the Lo Cut parameter.
Hi Soften
Hi Soften is a special filter used to "soften" the
high frequencies of Reverb diffuse field. This is
not a simple Hi Cut filter but a complex set of
filters working together to remove the
frequencies that give a "brittle" or “harsh”
sounding Reverb. Hi Soften is scaled/linked to
the Hi Cut and Hi Decay parameters.
Hi Cut
Range: 20 to 20kHz
Attenuates the high-end frequencies.
Decay Crossover
Lo Decay
Range: 0.01 to 2.5
Decay multiplier in relation to the Master Decay,
for the frequencies below the Lo Xover setting.
LoMid Decay
Decay multiplier in relation to the Master Decay,
for the frequencies above the Lo Xover and
below the Mid Xover settings.
HiMid Decay
Decay multiplier in relation to the Master Decay,
for the frequencies above the Mid Xover and
below the Hi Xover settings.
Hi Decay
Decay multiplier in relation to the Master Decay,
for the frequencies above the Hi Xover setting.
Lo Xover
Sets the Cross-over frequency between the Lo
and LoMid Decay.
Mid Xover
Sets the Cross-over frequency between the
LoMid and HiMid Decay.
Hi Xover
Sets the Cross-over frequency between the
HiMid and Hi Decay.