TC Electronic REVERB 4000, User Manual

Page: 18 / 61

16
UTILITY -
FRONT PANEL OPERATION
Display
Viewing Angle
Adjusts the optimal display viewing angle.
MIDI
Channel
Range: 1-16 or Omni
When “Omni” is selected Reverb 4000 receives
MIDI information on all channels.
SysEx ID
Range: 0 to 127
Sets the Reverb 4000 own SysEx ID for
identification in larger MIDI setups.
MIDI Input
Program Change
Range: On/Off
Determines whether Reverb 4000 should
respond to incoming program changes or not.
Control Change
The Reverb 4000 allows for both extensive and
precise control of parameter values via MIDI
Sysex. However, a simple mode is also
available where a few important parameters
can be accessed via standard MIDI CC’s.
In the Algorithm chapter all parameters
controllable via MIDI CC are marked with
corresponding MIDI CC numbers. A complete
list is also available in the appendix section.
Following CC modes are available:
Off:
No response to incoming MIDI CC messages.
On:
The three Home-page parameters from each
algorithm can be controlled by a given set of
controllers.
The Reverb 4000 responds to either Single or
Double Precision Controllers.
The Utility menu
This is where you setup:
- MIDI Input/Output
- MIDI mapping
- MIDI dump functions
- Bank copy functions to and from PCMCIA
cards for backup/restore
- Display Viewing Angle for viewing comfort
- Other various utilities
A few important parameters can be controlled
via Standard MIDI Control Change (MIDI CC),
but all parameters can be controlled via MIDI
Sysex. Complete Sysex documentation can be
downloaded via www.tcelectronic.com
Overview of the Utility menu: