TC Electronic G-Force, User Manual

Page: 49 / 60

THE BLOCKS
47
algorithm. Range +/-50
Color
Sets the tonal color of the initial reflections.
When set to Auto it is linked to High color
Wool - Warm - Real - Clear - Bright - Crisp - Glass -
Extreme.
Mix
This parameter sets the mix relation between the dry (direct)
and the wet signal. If you are using G-Force as an insert
effect this means that your direct signal goes through the G-
Force.
In Level
Controls the input level of the block.
Out Level
Controls the output level of the Reverb block.
Mute mode
See Mute mode in the introduction of this chapter.
Output
The Output section contains a master output level control
and a set of Speaker Filters. All parameters in the Out
Section are global only, which means that they are not
included when you store a preset.
Level
In the Output block, you will find an overall outlevel in
addition to the potentiometer on the front panel. This
Outlevel can be controlled via MIDI or pedal, set up in the
I/O Setup, Control display via the Main Volume parameter.
The Outlevel is not included in the preset.
Speaker Filters
The Speaker Filters are meant to roll off some high and low
frequencies like a guitar cabinet would do. This will make it
possible to rehearse with the G-Force on your home stereo
using a preamp or pedal and a pair of headphones.
Filters
Sets the Speaker Filter On/Off.
Locut
The Locut filter cutoff frequency can be either 40 or 80Hz.
Hicut
The Hicut cutoff frequency can be 2,5kHz, 3kHz, 3,5kHz,
4kHz, 4,5kHz or 5kHz.